Releasing The Parking Brake; Starting And Stopping The Engine - Toro 72105 Wheel Horse 268HE Operator's Manual

Releasing the Parking Brake

1. Push down on the brake pedal (Fig. 3). The
parking brake lever should release.
2. Gradually release the brake pedal.
Figure 3
1. Brake pedal
Starting and Stopping
the Engine
Starting
1. Sit down on the seat.
2. Set the parking brake; refer to Setting the
Parking Brake, page 12.
Note: The engine will not start unless you set
the parking brake or fully depress the
brake pedal.
3. Push the PTO (power take off) to "OFF"
(Fig. 4).
4. Move the choke lever to "ON" (Fig. 4).
Note: An engine that has been running and is
warm may not require step 4.
1
2
1201
2. Parking brake lever
5. Move throttle lever to "FAST" (Fig. 5).
6. Turn the ignition key clockwise and hold it in
the "START" position (Fig. 6). When the engine
starts, release the key.
IMPORTANT: If the engine does not start
after 30 seconds of continuous cranking, turn
the ignition key to "OFF" and let the starter
motor cool; refer to Troubleshooting, page 41.
7. After the engine starts, move the choke lever to
"OFF" (Fig. 5). If the engine stalls or hesitates,
move the choke lever back to "ON" for a few
seconds. Then move the throttle lever to desired
setting. Repeat this as required.
1
1206
Figure 4
1. PTO—Off
2. Choke–On
3. Choke–Off
1
Figure 6
1. Off
2. Lights
Operation
2
1
3
2
Figure 5
1. Fast
2. Slow
2
3
4
3. Run
4. Start
1207
1208
13