Adjusting The Discharge Chute And Chute Deflector; Disengaging The Rotor Blades; Stopping The Engine - Toro Powerlite 38273 Operator's Manual

Engaging the Rotor Blades
To engage the rotor blades, hold the control bar against
the handle (Figure 20).
1. Control bar

Disengaging the Rotor Blades

To disengage the rotor blades, release the control bar
(Figure 21).

Stopping the Engine

To stop the engine, pull the ignition key outward until
it clicks into the Off position (Figure 22) or move the
choke lever fully to the right (Figure 16).
Figure 20
Figure 21
Adjusting the Discharge Chute
and Chute Deflector
To adjust the discharge chute, move the chute handle as
shown in Figure 23.
1. Chute handle
To raise or lower the angle of the chute deflector, press
the trigger on the chute deflector and move the chute
deflector up or down (Figure 24). Release the trigger to
lock the chute deflector in place.
1. Trigger
Clearing a Clogged Discharge
Chute
Important: Hand contact with the rotating rotor
blades inside the discharge chute is the most
common cause of injury associated with machine.
Never use your hand to clean out the discharge
chute.
12
Figure 22
Figure 23
Figure 24
2. Chute deflector