Toro 22317 Dingo 220 Operator's Manual page 30

DANGER
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.
1. Remove the battery from the traction unit.
Important: Never fill the battery with distilled
water while the battery is installed in the traction
unit. Electrolyte could be spilled on other parts
and cause corrosion.
2. Clean the top of the battery with a paper towel.
3. Remove the filler caps from the battery (Figure 29).
4. Slowly pour distilled water into each battery cell
until the electrolyte level is up to the Upper line
(Figure 29) on the battery case.
Important: Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe
corrosion and damage to the chassis.
5. Wait five to ten minutes after filling the battery cells.
Add distilled water, if necessary, until the electrolyte
level is up to the Upper line (Figure 29) on the
battery case.
6. Install the battery filler caps.
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important
to prevent battery damage when the temperature is
below 325F (05C).
1. Check the electrolyte level; refer to Checking
Electrolyte Level.
2. Make sure the filler caps are installed in the battery.
3. Charge the battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 4 to 6 amps (Figure 30). Do
not overcharge the battery.
4
2
1. Positive battery post
2. Negative battery post
4. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 30).
5. Replace the battery cover.
30
3
1
G003792
Figure 30
3. Red (+) charger lead
4. Black (-) charger lead