Toro 22317 Dingo 220 Operator's Manual page 13

To slow or stop, move the traction control levers to
neutral.
Attachment Tilt Lever
To tilt the attachment forward, slowly push the
attachment tilt lever forward.
To tilt the attachment rearward, slowly pull the
attachment tilt lever rearward.
Loader Arm Lever
To lower the loader arms, slowly push the loader arm
lever forward.
To raise the loader arms, slowly pull the loader arm lever
rearward.
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in forward direction,
slowly pull the auxiliary hydraulics lever upward and
then rearward.
To operate a hydraulic attachment in reverse direction,
slowly pull the auxiliary hydraulics lever upward and then
push it forward. This is also called the detent position
because it does not require operator presence.
Speed Selector Lever
Move the speed selector lever to the forward position to
set the traction drive, loader arms, and attachment tilt to
high speed and the auxiliary hydraulics to low speed.
Move the speed selector lever to the rearward position to
set the auxiliary hydraulics to high speed and the traction
drive, loader arms, and attachment tilt to low speed.
WARNING
If you move the speed selector lever while the
traction unit is in motion, the traction unit will
either stop suddenly or accelerate quickly. If you
operate the traction unit with the speed selector
lever in an intermediate position, the traction unit
will operate erratically and may be damaged. You
could lose control of the traction unit and injure
bystanders or yourself.
• Do not move the speed selector lever when the
traction unit is in motion.
• Do not operate the traction unit when the speed
selector is in any intermediate position (i.e.,
any position other than fully forward or fully
rearward).
Hour Meter
The hour meter displays the number of hours of
operation that have been logged on the traction unit.
After 50 hours and then every 100 hours thereafter (that
is at 150, 250, 350, etc.) the screen displays CHG OIL
to remind you to change the oil. After every 100 hours,
the screen displays SVC to remind you to perform the
other maintenance procedures based on a 100, 200, or
400 hour schedule. These reminders come on starting
three hours prior to the service interval time and flash at
regular intervals for six hours.
13