Inspecting The Constant-Velocity Boot; Adjusting The Shift Cables; Adjusting The High-To-Low Cable; Adjusting Differential-Lock Cable - Toro 07385 Workman HDX-D Operator's Manual

Inspecting the
Constant-Velocity Boot
4-Wheel-Drive Models Only
Service Interval: Every 200 hours (4-wheel-drive models
only).
Inspect the constant-velocity boot for cracks, holes, or a loose
clamp. Contact your Authorized Toro Distributor for repair
if you find any damage.

Adjusting the Shift Cables

Service Interval: After the first 10 hours
Every 200 hours
1. Move the shift lever to the N
2. Remove the clevis pins securing the shift cables to the
transaxle-shift arms
1. Shift arm (1st to reverse)
2. Shift arm (2nd to 3rd)
3. Loosen the clevis jam nuts and adjust each clevis, so
that the cable free play is equal forward and backward
relative to the hole in the transaxle-shift arm (with the
transaxle lever free play taken up in the same direction).
4. Install the clevis pins and tighten the jam nuts when
finished.
position.
EUTRAL
(Figure 52).
Figure 52
3. Shift arm (High to low)
Adjusting the High-to-Low
Cable
Service Interval: Every 200 hours
1. Remove the clevis pin securing the high-to-low cable
to the transaxle
2. Loosen the clevis jam nut and adjust the clevis so that
the clevis hole aligns with the hole in the transaxle
bracket.
3. Install the clevis pin and tighten the jam nut when
finished.
Adjusting Differential-Lock
Cable
Service Interval: Every 200 hours
1. Move the differential-lock lever to the O
2. Loosen the jam nuts securing the differential-lock cable
to the bracket on the transaxle
1. Differential-lock cable
2. Transaxle bracket
3. Adjust the jam nuts to obtain a 0.25 to 1.5 mm (0.01 to
0.06 inch) gap between the spring hook and the OD of
the hole in the transaxle lever.
4. Tighten the jam nuts when finished.
46
(Figure 52).
FF
(Figure 53).
Figure 53
3. Spring
4. 0.25 to 1.5 mm (0.01 to
0.06 inch) gap
position.