General Specifications; Dimensions - Toro 04130 Greensmaster 500 Operator's Manual

General Specifications

Engine
Fuel capacity
Traction drive
Reel Drive
Reel Clutch
Ground speed
Traction drum
Reduction, Engine to
Traction Drum
Traction Drive Clutch
Differential
Handle
Traction unit construction
Reel construction
Width of cut
Height of cut
Clip frequency
Bedknife/bedbar
Front Rollers
Weight

Dimensions

Width
Height
Length
Kawasaki, 4-cycle, 3.7 (2.7 kw) air cooled OHV engine, 3600 RPM, 7.57 cu in.
(124 cc) displacement, cast iron cylinder sleeve; electronic ignition with integral
lighting coil; maximum noise suppression muffler; 83 dB(A) at operator's ear
2.64 qt. (2.5 l); regular grade unleaded gasoline
"A" section "V" belt on 2.0 P.D. and 3.70 P.D. to countershaft (1. 85:1) 18T and
48T gear) 2.67:1 and 20T and 56T gear (2 . 8:1). All gears 16 pitch, 20_ involute
full depth, 1/2 in. (13 mm) wide. Gears running in oil.
"A" section V-belt on 2.0 P.D. and 3.70 P.D. to countershaft (1. 85:1) 3/8 in. pitch x
3/16 in. wide chain on 20T and 14T sprockets from countershaft. Reduction Engine
to Reel – 1.30:1.
Engaging jaw-type, hand operated at transaxle.
2.1 mph (3.4 Km/hr) at 1600 RPM and 4.0 mph (6.4 Km/hr.) at 3100 RPM.
6 in. (15.2 cm) diameter solid rubber on 16 gauge (1.5 mm) steel rims. Two
sections running on ball bearings.
13.86:1
Friction Disk type – Hand operated latch and bail at handle.
Enclosed spur gears
7/8 in. diameter, 17 gauge welded steel tubing with formed steel reinforcement
panel.
Cast aluminum housing.
Cast aluminum and zinc side plates, aluminum extrusion back plate. Reel unit
independent of traction unit and catcher. 3-1/2 in. (89 mm) diameter 9 blade,
welded tubular construction. Reel blades, high carbon heat treated steel. Reel
bearings, taper roller with adjustment.
21 in. (53.3 cm)
1/8 to 11/16 in. (3 to 17 mm).(Optional micro-cut bedknife 1/16" to 11/16")
0.197 in. (5.0 mm).
Single edge high carbon steel knife, extra hard for long life, screwed to extruded
aluminum one-piece bed bar and back plate.
2 in. (51 mm) O.D. Steel tube with ball bearings, moisture excluding oil seals and
replaceable wear sleeves.
186 pounds with catcher and cutting unit.
27 in. (0.69 m)
44-3/4 in. (1.1 m)
with handle
60 in. (1.5 m)
including handle and
catcher
8