Electrical Schematic; Storage - Toro 04130 Greensmaster 500 Operator's Manual

Electrical Schematic

INTEGRAL
LIGHTING
COIL

Storage

Drain gasoline from fuel tank. Start engine and let it
run at slow speed until it stops because all gasoline is
used.
Drain oil from crankcase: refer to Engine Operator's
Manual. However, do not fill crankcase with oil at this
time.
Remove grass clippings, dirt and grime from external
parts of mower housing and engine. Also clean the
engine cooling system.
Clean carbon from internal parts of engine and
re–assemble engine.
Pull wire off spark plug and clean area around plug so
foreign matter cannot fall into cylinder when plug is
removed. Remove plug from cylinder head and pour
two tablespoons (25 ml) of engine oil into spark plug
hole. Pull recoil starter handle slowly to distribute oil
on inside of cylinder. Reinstall spark plug. If torque
wrench is not used, tighten plug firmly. DO NOT
INSTALL WIRE ON SPARK PLUG.
Remove the belt cover over left side of machine.
Inspect the belt for excessive wear or damage. Repair
or replace as necessary. Assure belt is in disengaged
position.
SPARK PLUG
COMBINATION
IGNITOR/IGNITION
COIL
SWITCH
ENGINE IGNITION,
OPEN TO RUN
Note: TORO Re–Kote "touch–up" paint is available from
an Authorized Toro Service Dealer or Distributor. The
spray paint dries in minutes to a glossy, factory–finish.
27
Check condition of reel blades and bedknife: repair
and sharpen as necessary; refer to Reel And Bedknife
Grinding.
Lubricate mower: refer to Lubrication.
Clean the air cleaner.
Check and tighten all capscrews, screws, bolts, nuts
and mating parts. If any part is damaged, repair or
replace it.
"Touch up" all rusted or chipped paint surfaces. Make
sure to sand affected area before painting.
Fill crankcase with oil: refer to Engine Operator's
Manual.
Store the mower in a clean, dry place. Cover the
mower to protect it and keep it clean.