Swash Plates Adjustment - Carson SKY EAGLE Instruction Manual

Connection Diagram
k. Swash Plates Adjustment
1. Inspection of the swash plates
Tum on the transmitter. Bring the throttle and the throttle trim-
ming into the lowest position.
And put the elevator trim and aileron trim in the neutral
position. Then re-connect the power cable of the helicopter
to check whether or not the swashplate is in a horizontal level
after the reposition of the elevator and aileron servos.
Polarity Assignment Diagram
12.6 V 8.4 V 4.2 V O V
Charging jack for
7.4 V battery pack
Charging jack for
11.1 V battery pack
Wrong method
Correct method
CARSON Helikopter SKY EAGLE 50 070 7042
Charger
Battery

2. Swash plates adjustment

If the swashplate is not horizontal, you can adjust through the
following two steps:
1. Servo adjustment. Loosen the screws of the servos and
remove the round servo horn. Re-connect the power of your
tandem helicopter. After the servos are initialized, adjust the
angles to 90° between I-shape ballcrank and its servo pulling
rod, L-shape ballcrank and its servo pulling rod, respectively.
Then assemble the round ballcrank and
tighten the screw.
2. Servo linkage rod adjustment. Adjust the length of the servo
linkage rod to make the swashplate horizontal.
Chassis picture on the next page.
Status LED
Input jack
Power adapter
19
GB