Control Panel; On/Stand-By Button; Power Led - Quick SBC 1100 ADV PLUS FR User Manual

OPERATING
GB

CONTROL PANEL

The control panel is made-up of three LED, a 7 segment display and a button:
POWER LED, CHARGE PHASE LED (BULK, ABSORPTION, FLOAT) ERROR LED, STATUS display and ON/
STAND-BY button (see fig.4).
FIG.4

ON/STAND-BY BUTTON:

Use this button to put the battery charger in stand-by mode. To activate this mode simply press the button
quickly (press and release in less than one second). To take the battery charger out of stand-by mode,
press the button quickly again or disconnect the battery charger from the AC power supply and then
connect it up again.
The information supplied by the LEDS are listed as below:

POWER LED

LED COLOUR DESCRIPTION
OFF No mains power
Green Power ON
Flashing Battery charger in stand-by mode
CHARGE PHASE LED
LED COLOUR LED STATUS
OFF -
Red Fixed
Orange Fixed
Green Fixed
Red Flashing
Orange Flashing
Green Flashing
ERROR LED
LED COLOUR DESCRIPTION
OFF No problem with manual reset
Red Problem with manual reset (see error codes)
26
(BULK, ABSORPTION, FLOAT)
DESCRIPTION
No output power
BULK phase - charge at constant current
ABSORPTION phase - charge at constant voltage
FLOAT phase - float charge
BULK phase - charge at constant current - digital control of the parallel units on
ABSORPTION phase - charge at constant voltage - digital control of the parallel units on
FLOAT phase - float charge - digital control of the parallel units on