Sound Adjustment - Toshiba 32P2400 Series Owner's Manual

Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
• Use the menus: PICTURE, Picture Settings and
Noise Reduction
• Use the items: Auto Clean, MPEG NR and DNR
• Use the modes: Low, Middle, High and Off
Using the Ambient Type
Set the ambient light environment to help
Intelligent Auto View (or AutoView : 32P2400
Series / 32L2400 Series) function more eff ectively.
This can be set when Picture Mode is set to
Intelligent Auto View (or AutoView : 32P2400
Series / 32L2400 Series).
• Use the menus: PICTURE and Ambient Type
• Use the items: Fluorescent Light and Light Bulb
Adjusting the Colour Management
You can adjust the picture colour quality by
selecting from 6 base colour adjustments : Red,
Green, Blue, Yellow, Magenta or Cyan.
• Use the menus: PICTURE, 3D Colour
Management (On) and Base Colour Adjustment
• Use the items: Hue, Saturation and Brightness
Resetting the Base Colour Adjustment
• Use the menus: PICTURE, 3D Colour
Management (On) and Base Colour Adjustment
• Use the item: Reset
Using the Active Backlight Control
(except for 32P2400 Series / 32L2400 Series)
In order to improve screen visibility, the Active
Backlight Control sets the screen brightness
automatically during dark scenes.
• Use the menu: PICTURE
• Use the item: Active Backlight Control
Using the Picture Analyser
Displays the picture histogram.
• Use the menus: PICTURE and Picture Analyser.
Histogram: Shows the bright and dark areas of
the displayed picture, and the distribution of
colours in a graph.
Contrast Curve: Shows the correction curve,
which improves the expressive feel of the
displayed picture, in a graph.
• To close the Picture Analyser screen, press EXIT.

Sound adjustment

Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize
stereo/bilingual programmes depending on the
broadcast signal.
Mono mode
If you experience noise or poor reception of any
stereo/bilingual programme, set the MTS mode to
Mono.
Noise will be reduced and reception may improve.
• Use the menu: SOUND
• Use the item: MTS
NOTE:
If you experience noise with a particular programme
on whose channel reception is usually good, try setting
MTS mode to Auto, then press s to switch to
e Mono (monaural).
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
• Use the menu: SOUND
• Use the item: Dual
NOTE:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV
is turned off .
Selecting the bilingual programmes
When a bilingual programme is received, j Dual
appears and press s .
Display
j Dual 1
Sub II sound
J Dual 2
e Mono
NOTE:
These settings are not stored in the TV memory.
– 16 –
Sound to be heard
German stereo/
NICAM
bilingual broadcast
Sub I sound
Main sound
Sub sound
Main sound —