Samsung NY58J9850WS Installation Manual page 34

Installation instructions
Installing a 3-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage and
voltage to make the connection. Connect wires according to Step 4 depending on the
number of wires.
• Wire used, location and enclosure of splices, etc., must conform to good wiring practices and
local codes.
Neutral
terminal
Black
Black
Wire tips
Installing a 4-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage and
voltage to make the connection. Connect wires according to this Step 4 depending on the
number of wires.
• Wire used, location and enclosure of splices, etc., must conform to good wiring practices and
local codes.
34 English
Ground
strap
White
Red
White
Red
1. Loosen the 3 lower terminal screws from
the terminal block.
2. Insert the center bare wire (white/neutral)
tip through the bottom center terminal
block opening. On certain models, the
wire will need to be inserted through the
ground strap opening and then into the
bottom center block opening.
3. Insert the two side bare wire tips into the
lower left and the lower right terminal
block openings.
4. Tighten the screws until the wire is firmly
secured (35 to 50 inch-lbs.). Do not over-
tighten the screws since it could damage
the wires.
5. Go to step 6 on page 34 and proceed with
the installation.