Chapter Chapter 8 8 8 8 Security Chapter - Monoprice MW368R User Manual

8.1 8.1 Client Client Filter Filter
8.1 8.1 Client Client Filter Filter Settings
You can enable client filtering to control a client computer's access to specific ports of the
internet.
�
Filter Filter Filter Filter Mode Mode Mode Mode: : : : You can select either Permit
�
Access Access Access Policy: Access Policy: Policy: Policy: Select an unused number from the drop-down list.
� Remark: Remark:
Remark: Remark: Input a simple description of the configured filter rule (you may leave it
blank if you wish).
� Start/End Start/End IP: IP:
Start/End Start/End IP: IP: Enter the Start IP and End IP address range.
� Port:
Port: Port: Enter the range of ports to be controlled. The two values may be the same, Port:
indicating a single port rather than a range of ports.
�
Type Type Type Type: : : : Select a protocol type (TCP, UDP, or Both) from the drop-down list.
� Time: Time: Time: Time: Select the starting and ending time range for the filter to be in effect.
� Date: Date:
Date: Date: Select the starting and ending day(s) to apply the access policy.
� Enable: Enable:
Enable: Enable: Check the Enable box to apply the filter after clicking the Ok
Chapter Chapter 8 8 8 8 Security
Chapter Chapter
Settings Settings
Settings
Security Settings
Security Security Settings Settings Settings
Permit Permit Permit only only or Forbid only only Forbid only Forbid Forbid
47
only. only only
Ok Ok
Ok button.