Wan Speed - Monoprice MW368R User Manual

refresh automatically every five minutes.
� IP IP IP IP address: address: address:
address: the IP address of the computer whose traffic is being calculated.
� Uplink Uplink rate: rate:
Uplink Uplink rate: rate: the data sending speed per second in KBytes/s.
�
Downlink Downlink Downlink Downlink rate: rate: rate: rate: the data receiving speed per second in Kbytes/s.
� Sent Sent message: message:
Sent Sent message: message: the number of data packets sent out through the router.
� Sent Bytes:
Sent Sent Sent Bytes: Bytes: the total volume of data that is sent out through the router. Bytes:
�
Received Received Received Received message: message: message: message: the number of data packets received through the router.
� Received Received Bytes: Bytes:
Received Received Bytes: Bytes: the total volume of data received through the router.
4.9 4.9 WAN WAN Speed Speed
4.9 4.9 WAN

WAN Speed

Speed
This section allows you to configure the WAN speed. It is recommended that the default
settings are retained.
� � � �
AUTO: AUTO: AUTO: AUTO: This is the default setting. In this mode, the router will select the best data
speed for your network. Keep this selection unless you are experiencing connection
and performance issues.
�
10M 10M 10M 10M HALF-duplex: HALF-duplex: HALF-duplex: This is the slowest data rate. Select this value if your router's HALF-duplex:
WAN port does not function properly when connected to an Ethernet cable, which
may be caused by degraded performance due to the cable's excessive length.
�
10M 10M 10M 10M FULL FULL FULL FULL-duplex: -duplex: Select this value to improve WAN port performance. -duplex: -duplex:
� 100M 100M HALF-duplex HALF-duplex HALF-duplex: : : : Choose this selection it to set the router's WAN port to work at
100M 100M HALF-duplex
100Mbps in half duplex mode.
� 100M 100M 100M 100M FULL-duplex FULL-duplex FULL-duplex FULL-duplex: : : : This is the fastest data rate. Select this value to force the WAN
28