Troubleshooting - General International AC1104 Setup And Operation Manual

5. Drain all moisture from air tank(s).
6. Fully close drain valve(s).
7. Protect electrical cord and air hoses from damage (such as being
stepped on or driven over). Wrap all cords and hoses loosely around
air compressor.
8. Place air compressor in a cool, dry, safe, and indoor location.
Always inspect the tool before use, and make sure it is in good working
condition. Make sure all air vents are clear, (use compressed air to clean
the machine where possible). Check the power cable to make sure it is
intact and free from cracks, bare wires etc. Avoid using solvents when
cleaning plastic parts, most plastics are susceptible to damage from the
various types of commercial solvents.
TROUBLE
Compressor Will Not Start
Low Pressure
Safety Valve Releasing
Oil Discharge in Air

TROUBLESHOOTING

POSSIBLE CAUSE
1. Blown fuse or circuit breaker
tripped
2. Loose electrical connections
1. Restricted air filter
2. Defective check valve
3. Air leak in safety valve
1. Defective Pressure Switch
1. Too much oil in crankcase
2. Compressor overheated
3. Restricted oil breather cap
CORRECTIVE ACTION
1. Replace or reset fuse/circuit
breaker
2. Check wiring connections
1. Replace air filter
2. Replace check valve
3. Check valve by pulling on ring. If
condition persists, replace valve.
1. Replace pressure switch
1. Drain crankcase and refill to prop-
er level on oil sight glass
2. Reduce air pressure regulation
3. Clean or replace oil breather cap
141204
11