Standby - Miele TDA 150 C Operating Instructions Manual

Standby

To save energy, the display goes out
after 10 minutes and the indicator light
for the Start button starts flashing
slowly.
Reactivate from Standby
 Move the programme selector or
press Start. Neither will have any
effect if a programme is running.
On
Standby is activated and the indicator
lights will go out after 10 minutes:
– if a programme is not selected after
the dryer has been switched on,
– after a programme has started.
They will, however come on for 10
minutes at the end of the programme or
the end of the Anti-crease phase. The
buzzer (if selected) will sound for 10
minutes at the end of the programme.
Programmable functions
Not in current programme (factory
default setting)
As described under "On".
However, indicator lights will stay on
when the programme has started and
remain visible during the programme.
Off
Indicator lights will stay on while the
dryer is switched on.
Follow steps (,, ...) to
programme and store in memory.
Before you begin, ensure the
following:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is pointing
to Finish.
 Press the Start button and keep it
pressed in whilst carrying out steps
-.
 Switch the tumble dryer on.
 Wait until the indicator light for the
Start button lights up constantly . . .
 . . . and then release the Start button.
 Turn the programme selector to
Gentle smoothing.
The Empty the container indicator light
will flash eight times.
55