Table of Contents
Advertisement
Standby
To save energy the display and
buttons will go out after 10 minutes
and only the Start/Stop button will
flash slowly. You can alter this setting.
However, standby mode will not occur
in the event of a fault.
Options
Standby switched on:
The display and buttons will go
out after 10 minutes . .
. . . if no selection is made after
switching the dryer on.
. . . after a programme has
started.
However, the display and buttons
will remain lit up for 10 minutes
after a delay start time has
elapsed, after the end of the
programme or at the end of the
anti-crease phase. The buzzer, if
selected, will sound for 10
minutes after the end of the
programme.
Not in current programme
(factory default setting)
As described under .
However, the display and buttons
will remain lit up during the
programme.
Off
The display and buttons will
remain lit up while the dryer is
switched on.
Programmable functions
To switch the display and buttons back
on again
– Turn the programme selector or press
a button. Neither will have any effect
if a programme is running.
– Open the door while the dryer is
switched on.
75
Advertisement
Table of Contents
