Setup; Installing The Handle - Toro 22179TE Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
4 Oval-head bolt
2 Bolt (5/16 x 7/8 inch)
2 Bolt (5/16 x 1-1/2 inches)
4 Washer
8 Locknut (5/16 inch)
3
Cable tie
Procedure
1. Mount the lower handle to the mower housing with
2 bolts (5/16 x 7/8 inch), 2 bolts (5/16 x 1-1/2
inches), 4 washers, and 4 locknuts (Figure 3).
Description
Handle
Oval-head bolt
Bolt (5/16 x 7/8 inch)
Bolt (5/16 x 1-1/2 inches)
Washer
Locknut (5/16 inch)
Cable tie
Self-tapping screw
Fuel tank
No parts required
Qty.
1
4
2
2 Install the handle.
4
8
3
2
Install the fuel tank and fuel line.
1
–
Fill the crankcase with oil.
1. Housing
2. Lower Handle
3. Washer
Note: Install the washers with the cup side facing
the handle.
Note: You can adjust the handle height for more
comfortable operation. Securing the lower handle
end in the upper hole lowers the handle; securing the
lower handle end in the lower hole raises the handle.
2. Install the upper handle onto the lower handle and
secure the upper handle with 4 oval-head bolts, 4
washers, and 4 locknuts (Figure 4).
Note: Insert the oval-head bolts through the upper
and lower handle sections so that the locknuts are on
the outside of the handle.
7
Use
Figure 3
4. Locknut
5. Bolt (5/16 x 1-1/2 inches)
6. Bolt(5/16 x 7/8 inch)