Table of Contents
Advertisement
Figure 34
1. Screws (4)
7. Remove the shield and brush or blow all the debris
from under the shield and around the blade brake
clutch system.
8. Install the shield using the 4 screws that you
previously removed.
9. Install the blade, the anti-scalp cup, and the 2 blade
nuts.
10. Return the mower to its operating position.
11. Connect the wire to the spark plug.
2. Blade brake clutch shield
Storage
To prepare the mower for off-season storage, perform
the recommended maintenance procedures. Refer to
Maintenance.
Store the mower in a cool, clean, dry place. Cover the
mower to keep it clean and protected.
Preparing the Fuel System
Gasoline can vaporize if you store it over long
periods of time and explode if it comes into
contact with an open flame.
• Do not store gasoline over long periods of
time.
• Do not store the mower with gasoline in the
fuel tank or the carburetor in an enclosure
with an open flame. (For example, a furnace
or a water heater pilot light.)
• Allow the engine to cool before storing it in
any enclosure.
Empty the fuel tank when mowing the last time before
storing the mower.
1. Run the mower until the engine stops from running
out of fuel.
2. Prime the engine and start it again.
3. Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
Preparing the Engine
1. While the engine is still warm, change the oil from
the crankcase. Refer to Changing the Engine Oil.
2. Remove the spark plug.
3. Using an oil can, add about one tablespoon of oil to
the crankcase through the spark plug hole.
4. Slowly rotate the engine several times, using the
starter rope, to distribute the oil.
5. Install the spark plug but do not connect the wire to
the spark plug.
General Information
1. Clean the mower housing. Refer to Cleaning under
the Mower Housing.
2. Clean any dirt and chaff from the cylinder, cylinder
head fins, and blower housing.
25
Advertisement
Table of Contents
