Travel Lock Function; Operation - ALDI 9113956 Instructions For Use Manual

05. Travel Lock Function

The shaver can easily be protected against accidental activation, e.g.
when travelling.
NOTE: The travel lock function can only be activated when the appli-
ance is switched off. When charging is started, the travel lock function
will be deactivated automatically.
How to activate the travel lock function
1. Switch off the shaver.
2. Press and hold the on/off switch
of the shaver is locked.
3. Briefly press the on/off switch a few times (for less than 5 s) to check
if the travel lock function has been activated. If the travel lock func-
tion is active, a padlock symbol will flash on the display
4. The on/off switch is temporarily without function; accidental activa-
tion of the appliance and discharging of the battery are prevented.
How to deactivate the travel lock function
1. Press and hold the on/off switch
lock function is deactivated and the shaver ready for use.
2. The travel lock function will also be deactivated by connecting the
shaver to the mains.

06. Operation

WARNING! Risk of injury
Do not operate the shaver if the shaving foil is damaged.
Independent of the charging state of the batteries, you are always
able to use the shaver connected to the mains power.
10
www.aquarius-service.com
MODELL: 9113956 PRODUCT CODE: 91628 11/2014
;
(7) for more than 5 s. The switch
.
LOCK
;
(7) for more than 5 s; the travel
AFTER SALES SUPPORT
00800-36 46 36 00
GB IRE
Hotline free
1. In order to use the connected to the mains power, ensure that the
shaver is switched off.
2. Connect the wall power supply to the shaver.
3. Insert the wall power supply into an easily accessible power point.
4. Take off the protective cap.
;
5. Use the on / off switch (7) to switch on the shaver.
Shave
NOTES:
• The shaver is suited for dry as well as wet shaves (Wet & Dry).
ATTENTION! The shaver is not waterproof. The wet shave may
only be operated as cordless and never use in the shower or
in the bathtub.
• Initial applications may result in a temporary redness or irritation of
the skin, since the skin must first get used to this type of shaving. This
is normal and usually takes between 2 and 4 weeks.
1. Remove the protective cap / 3-day stubble attachment (2) from the
shaving head.
;
2. Use the on / off switch (7) to switch on the shaver.
3. Hold the shaver at a right angle to the surface of the skin and move
it carefully and in circular motion over your face.
4. Shave against the direction of beard growth.
5. At parts of the face that are harder to shave, such as the chin,
stretch the skin for a better result.
6. After shaving, switch off the shaver and clean the cutting elements
carefully. (→ 7. Cleaning and Care)
Trimming Long Hair
Use the hair trimmer on the rear of the shaver to shorten beard and
sideburns.
AFTER SALES SUPPORT
00800-36 46 36 00
GB IRE
Hotline free
www.aquarius-service.com
MODELL: 9113956 PRODUCT CODE: 91628 11/2014
11