Power On/Basic Controls; Target Information - Garrett ACE 400i Owner's Manual

POWER ON/BASIC CONTROLS

Battery Level Power ON/OFF
Indicator Button
Power ON/OFF—Hold this button for 1 second to turn power
ON or OFF.
Factory Reset —To restore factory settings, press and hold
the power button for 5 seconds (until the detector produces
a fast double beep).
Battery Level Indicator—Shows continuous status of battery
life. Replace batteries when 1 segment remains.
Frequency Adjust—While holding down the (/X) button,
use DISCRIM (+) or (-) to increase or decrease the frequency
setting. Choose from four minor frequency adjustments (F1
to F4) in order to minimize interference caused by electrical
sources or other metal detectors.
6 Garrett Metal Detectors
Frequency Adjust
controls

TARGET INFORMATION

Target ID Cursor
Target ID Legend
(Upper Scale)
Target ID Legend—Works with the Target ID Cursor to
indicate a target's probable identity, with Ferrous (iron)
targets at the left, non-ferrous targets that are thin or have
low conductivity in the middle, and thick or high conductivity
targets (e.g. thick silver) at the right.
Lower Scale—Displays the current discrimination pattern,
with lighted pixels indicating accepted targets and blank
pixels indicating rejected targets.
Target ID Cursor (Upper Scale)—Will display for every
target, but will produce audio only for targets accepted on the
Lower Scale.
Digital Target ID—Provides a value from 0 to 99 to identify
targets more precisely than the ID cursor.
Coin Depth Indicator—Shows the depth of a coin, or a
similar sized target. Note: targets larger than a coin may
display shallower than actual depth while targets smaller
than a coin may display deeper than actual depth.
The sample chart on the following page provides Digital
Target ID ranges of some commonly found items.
Discrimination Pattern
(Lower Scale)
Coin Depth
Indicator
Digital Target ID
7
ACE 400i
™