Toro 74920 TITAN ZX4820 Operator's Manual page 24

Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 1-1/2 to 4-1/2 inch
(38 to 114 mm) in 1/4 inch (6 mm) increments by relocating
the height-of-cut pin into different hole locations.
1. Push on the deck lift pedal with your foot and
raise the mower deck to the transport position (also
the 4-1/2 inch (114 mm) cutting height position)
(Figure 27).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 27).
3. Select a hole in the height-of-cut system corresponding
to the height-of-cut desired and, insert the pin
(Figure 27).
4. Push on the deck lift pedal with your foot and raise the
height-of-cut lever slightly to disengage the transport
lock. Lower the deck slowly until the pin makes contact
with the lever.
G010219
Figure 26
1
4
G010236
1. Deck lift pedal
2. Cut height pin
3. Height-of-cut positions
Using the Lock Positions
The deck can be locked in the highest height-of-cut or
transport position or the lowest height-of-cut position.
To lock the deck in the transport position:
1. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 4.5 inch
(114 mm) cutting height position) (Figure 27).
2. Remove the pin from the height-of-cut bracket
(Figure 27).
3. Select the lower hole on the lock decal and insert the
pin (Figure 27).
To lock the deck in the lowest height-of-cut position:
1. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 4.5 inch
(114 mm) cutting height position) (Figure 27).
2. Remove the pin from the height-of-cut bracket
(Figure 27).
3. Push on the deck lift pedal with your foot and lower
the mower deck to the lowest position.
4. Select the upper hole on the lock decal and insert the
pin (Figure 27).
24
5
3
2
Figure 27
4. Lock position. lowest
height-of-cut (use only for
deck removal)
5. Lock position. transport
position