Belt Routing Diagram
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
1. Installing the Handle
2
Oval-head bolts
2
Curved washers
2
Handle knobs
Procedure
1. Position the ends of the upper handle on the inside
of the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes,
with the bolt heads on the outside of the handle.
(Figure 3).
Description
Oval-head bolts
Curved washers
Handle knobs
Discharge chute
Washers
Locknuts
Knob
Qty.
2
2
Install the handle.
2
1
2
Install the discharge chute.
2
1
3. Install the curved washers and the handle knobs on
the oval-head bolts and tighten the knobs securely.
5
Use
Figure 3