Think Safety First - Toro 74280TE Operator's Manual

2. Lower the roll bar to the down position. There
are two down positions. See Figure 6 for the
positions.
3. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Figure 6
1. Full down position
Important: Ensure that the rear part of
the seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 7).
5. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Important: Always use the seat belt with
the roll bar in the raised position.
2. Down position with bagger
installed
1. Roll bar
2. Raised position

Think Safety First

Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
19
Figure 7
3. Pin
4. Hairpin cotter pin