Figure 45
4. Install the battery in the machine and connect
the battery cables; refer to Installing the
Battery.
Note: Do not run the machine with the
battery disconnected, electrical damage may
occur.
Servicing the Fuses
The electrical system is protected by fuses. It
requires no maintenance, however, if a fuse blows
check component/circuit for malfunction or short.
The fuses are as follows:
• Main, 20 amp, blade-type
• Alternator, 30 amp, blade-type
• Fan, 30 amp, blade-type
1. Unlatch the seat and raise the seat to gain
access to fuse holder (Figure 46).
Figure 46
1. Main F1-30 amp
2. Alternator F2-25 amp
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse (Figure 46).
39