Adjusting The Anti-Scalp; Adjusting The Flow Baffle; Rollers - Toro 74268CP Operator's Manual

Adjusting the Anti-Scalp

Rollers

Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. After adjusting the height-of-cut, adjust the
rollers by removing the flange nut, bushing,
spacer, and bolt (Figure 19 , Figure 20 and
Figure 21 ).
Note: The two middle rollers will not have a
spacer (Figure 20).
4. Select a hole so the anti-scalp roller is
positioned to the nearest corresponding
height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N•m) (Figure 19 ,
Figure 20 and Figure 21 ).
6. Repeat this adjustment on the other anti-scalp
rollers.
Figure 19
1. Anti-scalp roller
2. Spacer
3. Bushing
4. Flange Nut
5. Bolt
Figure 20
1. Anti-scalp roller
2. Bushing
Figure 21
1. Anti-scalp roller
2. Spacer
3. Bushing
Adjusting the Flow Bafe
The mower discharge flow can be adjusted for
different types of mowing conditions. Position the
cam locks and baffle to give the best quality of cut.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. To adjust the cam locks, swing the lever up to
loosen the cam lock (Figure 22).
4. Adjust the baffle and cam locks in the slots to
the desired discharge flow.
25
3. Flange Nut
4. Bolt
4. Flange Nut
5. Bolt