Replacing The Grass Deflector - Toro 30284 Operator's Manual

2. Set the height-of-cut to the 4 inch (101.6 mm)
position following the height-of-cut decal.
3. With the machine on level surface, position
one blade front-to-rear. Measure at A and
from level surface to the cutting edge of the
blade tips (Figure 87). For 36 inch mower
decks use Figure 88.
Figure 87
40 inch, 48 inch, and 52 inch Mower Deck shown
1. Measure from a level
surface
Figure 88
36 inch Mower Deck shown
4. The measurement should be 4 inch (101.6
mm).
5. If it does not measure correctly:
A. Adjust the rear tire pressure.
B. Adjust the caster fork spacers.
2. Measure blade at point A
C. Adjust the front mower deck support pins.
6. Check the carrier frame front-to-rear pitch.
Replacing the Grass
Deector
An uncovered discharge opening could
allow the lawn mower to throw objects in
the operator's or bystander's direction and
result in serious injury. Also, contact with
the blade could occur.
Never operate the lawn mower unless you
install a cover plate, a mulch plate, grass
deflector or bagger.
1. Remove the locknut, bolt, spring and spacer
holding the deflector to the pivot brackets
(Figure 89). Remove damaged or worn grass
deflector.
Figure 89
1. Bolt
2. Spacer
3. Locknut
4. Spring
59
5. Spring installed
6. Grass Deector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring