Table of Contents
Advertisement
8. Install the new belt onto the engine pulley and
spring loaded idler pulley (Figure 64).
9. Roll the belt onto the center pulley on the
mower deck (Figure 64). Use caution when
install the belt as tension will increase because
of the spring loaded idler pulley. Refer to
Figure 65 to roll the new belt onto the left
pulley for a 36 inch mower deck.
10. Install the heat shield to the engine deck and
carrier frame.
11. Adjust the belt guide an 1/8 inch (3 mm) from
the belt for 40, 48 and 52 inch mower decks
(Figure 64).
12. Install the belt covers onto the cutting unit and
secure the latches.
13. Install the carrier frame cover onto the carrier
frame and secure the latches.
48
Advertisement
Table of Contents
