Table of Contents
Advertisement
Figure 16
36 inch Mower Deck
1. Mower deck
2. Bolt
3. Spacer
5. In certain mowing conditions and terrain,
a mismatch of cutting height may be seen.
Adjusting the outside anti-scalp rollers to the
minimum setting of 3/8 inch (10 mm) will help
prevent the mower deck cutting too low on the
outside and minimize the mismatch.
Adjusting the Handle Height
The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter pins and clevis
pins from the drive levers and neutral locks
(Figure 17).
4. Anti-Scalp Rollers
5. Nut
Figure 17
1. Control rod
2. Clevis pin
3. Drive lever
4. Operator Presence Control
lever (OPC)
2. Loosen the nuts holding the swivel connected
to the speed control crank (Figure 18).
Figure 18
1. Speed control rod
2. Swivel
22
5. Left handle shown
6. Neutral lock
7. Hairpin cotter pin
3. Nut
Advertisement
Table of Contents
