Technical Specifications; Safety Notice - Turtle Beach EAR FORGE Z User Manual

Technical Specifications

Safety Notice

To avoid potential damage to the device, always disconnect all cables before transporting it.
WARNING: Permanent hearing damage can occur if a headset is used at high volumes for extended periods of
time, so it is important to keep the volume at a safe level. Over time, your ears adapt to loud volume levels, so a
level that may not cause initial discomfort can still damage your hearing. If you experience ringing in your ears
after listening with the headset, it means the volume is set too loud. The louder the volume is set, the less time it
takes to affect your hearing. So, please take care to listen at moderate levels.
• Before placing a headset on your ears, turn the volume down completely,
then slowly increase it to a comfortable level.
• Turn down the volume if you can't hear people speaking near you.
• Avoid turning up the volume to block out noisy surroundings.
3
• 50mm diameter speakers
• Speaker Frequency Response: 20Hz - 20kHz, >120dB SPL @ 1kHz
• Condenser Microphone Frequency Response: 50Hz - 15kHz
• Maximum analog input level with volume control on maximum setting: 2Vpp
(700mV rms)
• 3.5mm, 4-pole plug for line and mic output
• Mic mute switch
• Cable length: 4 ft. (1.2m)