Using Your Juicer - Kenwood JMP60 Instructions Manual

Misuse of your appliance can result in injury.
l
Do not let the cord touch hot surfaces or hang down where a
l
child could grab it.
Appliances can be used by persons with reduced physical,
l
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and if they
understand the hazards involved.
Only use the appliance for its intended domestic use.
l
Kenwood will not accept any liability if the appliance is subject
to improper use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as
l
the one shown on the underside of the appliance.
Important – UK only
The wires in the cord are coloured as follows:
l
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live
The appliance must be protected by a 3A
l
approved (BS1362) fuse.
WARNING: THIS APPLIANCE MUST BE
l
EARTHED.
Note:
For non-rewireable plugs the fuse cover MUST
l
be refitted when replacing the fuse. If the fuse
cover is lost then the plug must not be used until
a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement
may be obtained from your Kenwood Authorised
Repairer (see Service).
If a non-rewireable plug is cut off it must be
l
DESTROYED IMMEDIATELY. An electric shock
hazard may arise if an unwanted non-rewireable
plug is inadvertently inserted into a 13A socket
outlet.
This appliance conforms to EC Regulation
l
1935/2004 on materials and articles intended to
come into contact with food.
before using for the first time
Wash the parts: see 'care and cleaning'.
key
pusher
1
lid with hopper
2
scroll
3
filter basket
4
rotating wiper holder
5
juicing bowl
6
pulp spout
7
pulp container
8
power unit
9
juice spout
bk
anti-drip stopper
bl
reset button
bm
On/Off/Reverse switch
bn
juice jug
bo
clip on sieve
bp
cleaning brush
bq
sorbet attachment (if supplied)
br

using your juicer

1 Fit the pulp stopper
underside of the juicing bowl
(B)
until secure .
2 Fit the juicing bowl
aligning the
with the (graphic) on the power unit
the on the power unit
on turn it clockwise until the
with the (graphic) on the power unit
on the power unit
(graphic) on the bottom of the bowl
3 Place the filter basket
(E)
.
5
(graphic) on the bottom of the bowl
unlock graphic
4 Lower the wiper holder assembly into the juicing
bowl and align the
unlock graphic
(F)
the power unit
lock graphic / Fit the lid onto the unit and click in
is locked into place.
lock graphic / Fit the lid onto the unit and click into p
3
lter holder assembly into the juicing bowl and align (graphic) on the juicing bowl
with the (graphic) on the power unit
(A)
into the opening on the
and push in
6
(graphic) on the bottom of the bowl
to the power unit by
6
on the side of the bowl with
unlock graphic
(C)
. To lock the bowl
line up with the
lock graphic / Fit the lid onto the unit an
(D)
.
into the wiper holder
4
lter holder assembly into the juicing b
(graphic) on the juicing bowl
with the on the top of
. Ensure that the filter basket
switch graphic, on, o & reve
lter holder assembly into the juicing bowl and a
with the (graphic) on
(graphic) on the botto
unlock graphic
lock graphic / Fit the li
lter holder assembly
(graphic) on the juicin
switch grap