Whirlpool akr 758 ixl User And Maintenance Manual page 16

DESCRIPTION AND USE OF HOOD
Control panel
T1. Device ON/OFF
ON: control panel on, no active function.
OFF: disable all the functions in use, control panel off.
Note: the hood is equipped with an "automatic shutdown" function; if the control panel is on for more than 60 seconds, and no light or motor function is
selected, the hood turns off (OFF).
T2. Light OFF
With long press: gradual decrease of the intensity.
T3. Light ON
With long press: gradual increase of the intensity.
T4. ON/OFF Automatic operation
The hood automatically sets the extraction speed (power) 1, which will be increased if the environmental conditions detected by the hood sensor require it.
In the absence of variations in environmental conditions, after 5 minutes (if the hood is already operating at extraction speed (power) 1), the hood turns
off.
Note: for proper use of this function carry out the "Automatic operation parameters adjustment" (see related paragraph).
Note: during automatic operation, if the user adjusts the speed through other functions, the auto ventilation function is deactivated.
T5. Speed decrease / Motor OFF
T6. Motor ON / Speed increase
T7. Timed intensive speed ON/OFF
The hood will operate at intensive speed for 5 minutes, then it will return to the previously set speed.
To stop the timing mode press T7 again.
Note: if during the Timed intensive speed operation, the user adjusts the speed through other functions, the timing stops and the hood will return operating at
the previously set speed.
Automatic Operation parameters adjustment
To ensure proper use of the automatic operation perform the "Hood calibration" and "Hob selection".
Hood calibration
With display on (ON) and extraction off (OFF), press the T4 button for 5 seconds.
The extraction speed (power) 2 starts operating and the T4 button flashes to indicate that the hood calibration started and will last for about 15 minutes.
Note: to stop the calibration press T4 for 5 seconds; the calibration will be invalidated, and therefore it must be repeated.
Cooking hob selection
With display on (ON) and extraction off, press the T7 button for 5 seconds.
The buttons T5, T6 and T7 turn on.
Press the button T6 for gas hobs - the button flashes, then all the buttons turn off indicating that the selection was made.
Press the button T5 for electric hobs - the button flashes, then all the buttons turn off indicating that the selection was made.
1. Control panel
2. Grease filters.
3. LED lamps.
4. Telescopic flue.
GB14