Material Supplied; Installation Dimensions - Whirlpool akr 758 ixl User And Maintenance Manual

MATERIAL SUPPLIED

Remove all the components from the packets.
Check that all the components are included.
• Hood assembled with motor, lamps and grease filters installed.
• Instructions for assembly and use
• 1 electrical cable
• 1 assembly template
• 1 VNRF (2 pieces)
• 2 adjustment blocks
• 2 brackets for adjustment blocks
• 4 screws Ø 4x8
• 4 screws Ø 3.9 x 25
• 1 support bracket
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Note: the model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector.
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector.
IMPORTANT: if already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: check that air recirculation is ensured.
If the hood is not fitted with carbon filter/s, it/they must be ordered and installed before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualified technician must ensure that the materials
are suitable according to the type of wall/ceiling.

INSTALLATION DIMENSIONS

Adjacent wall units
900 mm min (90 cm wide model)
65 cm (gas or combi cookers)
50 cm (electric cookers)
• 6 wall plugs Ø 8mm
• 6 screws Ø 5 x 45
• 1 cable clamp
• 5 screw Ø 3.5 x 9.5
• 1 flue support bracket (3 pieces)
• 2 screws Ø 2.9 x 6.5
• 2 washers
• Filter Version only: 1 deflector (3 pieces)+ 4 screws Ø 2.9 x 6.5
Adjacent wall units
center line
hob surface
GB12