English MEDIUM ANGLE GRINDER DW830/DW840 Congratulations! SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE You have chosen a D WALT Power Tool. Years of The term “power tool” in the warnings refers experience, thorough product development and to your mains-operated (corded) power tool or...
English drugs, alcohol or medication. A moment of Power tools are dangerous in the hands of inattention while operating power tools may untrained users. result in serious personal injury. Maintain power tools. Check for Use personal protective equipment. misalignment or binding of moving parts, Always wear eye protection.
English f) Threaded mounting of accessories must spinning accessory may grab the surface and match the grinder spindle thread. For pull the power tool out of your control. accessories mounted by flanges, the arbour m) Do not run the power tool while carrying it at hole of the accessory must fit the locating your side.
English d) Use special care when working corners, b) Do not position your body in line with and sharp edges etc. Avoid bouncing and behind the rotating wheel. When the wheel, snagging the accessory. Corners, sharp at the point of operations, is moving away from edges or bouncing have a tendency to snag the your body, the possible kickback may propel the rotating accessory and cause loss of control or...
– Risk of burns due to accessories becoming hot INTENDED USE during operation. Your DW830/DW840 heavy-duty angle grinders – Risk of personal injury due to prolonged use. have been designed for professional grinding, – Risk of dust from hazardous substances.
WARNING: Guards must be used with spindle (12). this grinder. • Place the sanding sheet on the rubber backing DW830 - MOUNTING (FIG. B1 & C) pad. • Place the angle grinder on a table, spindle up. • Screw the threaded clamp nut (14) onto the • Align the lug (6) with the slot (7) in the bracket.
English cracks, tear or excess wear, wire brush for loose own weight. Supports must be placed or cracked wires. If power tool or accessory under the workpiece near the line of cut is dropped, inspect for damage or install an and near the edge of the workpiece on undamaged accessory.
English Rough Grinding • To run the tool, press the lock-off button (2) and the On/Off switch (1). Never use a cutting disc for roughing. • To stop the tool, release the On/Off switch. Always use the guard type 27. WARNING: Do not switch the tool On or The best roughing results are achieved when setting Off when under load.
Consult your dealer for further information on the appropriate accessories. ACCESSORY TABLE Max. Threaded [mm] Min. Periphical [mm] hole Rotation speed length [min. [m/s] [mm] DW830 DW830 11000 8 22.23 DW840 DW840 8000 DW830 DW830 11000 DW840 DW840 8000...
Page 16
English GRINDING AND CUTTING ACCESSORY CHART Guard Type Accessory Description How to Fit Grinder Depressed centre grinding disc TYPE 27 Type 27 guard GUARD Flap wheel Backing flange Type 27 depressed centre wheel Threaded clamp nut Backing pad/ sanding sheet Type 27 guard Rubber backing pad Sanding disc...