Connections - Totem KIN Sub User Manual

CONNECTIONS

Prior to making any connections make sure the power switch is set to OFF and the VOLUME dial is set to
its minimum value.
Two connections are possible with the TOTEM KIN Sub (low and high levels inputs). The low level connection
is the preferred method to achieve maximum performance. If low-level connections are not possible the
high level option may be incorporated.
low level connection
If connecting from a processor or a preamp, connect using a
pair of RCA interconnects from PRE-OUT (on preamplifiers
and surround processors) or SUB-OUT (on surround sound
processors) to the LOW LEVEL INPUT terminals on the
subwoofer.
When connecting from a SUB-OUT on a surround sound
processor, only one interconnect is required and should be
used with the RIGHT (LFE) LOW LEVEL INPUT RCA terminals
on the subwoofer.
high level connection
If your receiver or preamp does not have a SUB-OUT or
PRE-OUT, the high level connection may be used. From your
amplifiers SPEAKERS OUT, connect both pair of speaker
cables to the KIN Sub high-level input. (It is important to respect +/- polarity and the right/left channel
of your speaker wire). Using a second set of speaker wires, connect the KIN Sub high level out to the
appropriate loudspeaker, once again respecting polarity and channel. Connect the power cord to the
A.C. power inlet on your subwoofer and then directly to the A.C. receptacle on the wall.
Turn the unit on.
Note: The KIN Sub is available for 120V and 230V operation. Make sure that the voltage switch is in the
correct position for your domestic current before connecting it to the A.C. supply.
totemacoustic.com
7