Riding - ACTON R6 ROCKETSKATES Owner's Manual

D. Riding
Warning: Wear all suggested protective gears first including a helmet, ankle pads and
knee pads. Check that the power is off and sit down in a secure location. Firmly strap-
in the skates over your shoes. Make sure the Lead skate is on the foot that is most
comfortable for you to control.
1
Turn the power on by pressing the
hexagonal button at the rear end of the
skates. A brief music will be played and
the battery level LED will turn on. The
RocketSkates™ should be in brake mode.
3
Before kick-to-start, practice skating
with the RocketSkates turned off. To begin
skating, kick-off with one foot and let both
skates move with the momentum. You will
then feel the motors kick in.
If you need to pause while riding the RocketSkates™, push the heel of the Lead skates
down firmly until the RocketSkates™ have come to a complete stop for at least one
second. You are now able to lift your heel and walk on your toes. To begin riding again,
kick-off and repeat step 3.
When you finish riding, stop, sit down and turn the RocketSkates™ off before you
release the buckle.
2
Carefully stand up with toes of both
feet on the ground. Lean slightly forward
to avoid falling backward. Push the heel
of the lead foot firmly down to initiate.
DO NOT SKIP THIS STEP. The brake will
be released and the skates should start
moving freely.
4
To speed up, tilt the lead skate
forward. To slow down or brake, push the
heel of the Lead skate down. The Follower
skate will carry the same speed and brake
regardless of heel position.
9