Charging; Register & Setup - ACTON R6 ROCKETSKATES Owner's Manual

Changing the Footpad
The RocketSkates™ comes with a long footpad installed. This should fit shoe sizes
Women US 6, UK 4 and larger. Men US 6.5, UK 39 and larger. If your shoes size is
smaller, you have the option of swapping the footpad to a shorter one.
1
Use the attached wrench to remove
both screws on the footpad. Remove
the screws, nuts and washers.
B. Charging
Warning: For safety, please turn off the skates while charging.
Failure to recharge the battery at least once two months may result in an excessively
degraded battery performance. The battery requires charging for at least 2 hours
before first use.
The charging port is at the top center
section of the ankle cushion. Plug into
this port first, then plug the charger into
the wall outlet.
C. Register & Setup
RocketSkates™ can be connected with app through Bluetooth. Please download the
app "ROCKETSKATES" to your phone. Currently we only offer the app for Android
4.3+ and iOS iPhone 5+. When the app is opened for the first time, the registration
process will help you through some features that allow the RocketSkates™ to suit
you better and therefore enhance the your first experience. These features include an
adaptable motor performance for different weight and height. Please provide accurate
information at setup. For your safety, please set to BEGINNER mode on the app home
page to start with. Only set to NORMAL mode when you are a comfortable rider. Only
set to PRO mode when you are very familiar with the RocketSkates™.
2
Slide the new footpad on and put
the washers and nuts back and tighten
both screws.
During charging, the red light on
the charger should be on. Once the
RocketSkates™ are fully charged, the
light on the charger will turn green.
8