Triple Upper Bagger Components - Cub Cadet Time Saver Operator's Manual

Wide cut mower

Hide thumbs Also See for Time Saver:

Table of Contents

Enlarged version

Bagger Assembly & Installation

Triple Upper Bagger Components

Assembling The Bag Support Assembly

Note: The boot mounting assemblies can accommodate either a

twin or triple bagger. Since in most cases a triple bagging kit will

be purchased to accompany this unit, a triple bagger is shown

below. For twin bagging upper component mounting, follow the

same instructions below.

Locate the upright support bracket and the bag support

assembly. Assemble it by following these steps:

Lay the bag support assembly topside down with the mounting

bracket portion facing upwards.

Insert the notched end of the vertical support bracket into the

bag support assembly, as in Fig. 6-1, and secure with a

carriage bolt (710-0276) and flange lock nut (712-04063)

packed in with these support assemblies. See Fig. 6-2.

Figure 6-1

Figure 6-2

Mount Assembly on Tractor

With the mounting bracket assembly previously installed on

the tractor along with the chute discharge elbow and chute

extension, install the bagger components onto the tractor as

follows:

Install the bag support assembly onto the mounting bracket

assembly on the tractor by hooking it over the cross

mounting bracket outside of the two tabs. See Fig. 6-3.

Figure 6-3

Secure the bag support assembly in the left hole of the

mounting bracket using a hex bolt (710-3008) and flange

lock nut (712-04063) provided in with the support bracket

kit you are installing. See Fig. 6-4.

Figure 6-4

Table of Contents