Cub Cadet RZT-S Zero Operator's Manual page 22

4. Attach the hose coupler to the water port on the left of
your deck surface. See Figure 6-2.
CAUTION:
and no part of the hose is under the deck before
starting the rider.
5. Turn the water on.
6. While sitting in the operator's position, start the rider as
instructed beginning on page 16..
7. Engage the blades.
8. Remain in the operator's position with the cutting deck
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
9. Disengage the blades.
10. Turn the key switch to the OFF position to turn off the rider.
11. Turn the water off and detach the hose coupler from the
water port on your deck's surface.
12. After cleaning your deck with the Smart Jet™ system, return
to the operator's position, start the rider and engage the
blades. Keep the cutting deck running for a minimum of
two minutes, allowing the underside of the cutting deck to
thoroughly dry.
22
S 6— M
ection aintenance
Be certain the hose is clear of the deck
Figure 6-2
& a
djuStMentS
Lubrication
WARNING!
Before lubricating, repairing, or
inspecting, always stop the rider, disengage blades,
set parking brake and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel spindles and rims is equipped with a grease
fitting. See Figure 6-3. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of rider operation.
Grease Fittings
Figure 6-3
Tires
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire
pressure could cause the cutting deck to mow unevenly.
WARNING!
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.