Cub Cadet RZT-S Zero Operator's Manual page 12

Forward Drive Pedal
The forward drive pedal is located on the front, right
side of the running board. Press the forward drive
pedal forward to travel forward. Ground speed is also
controlled with the forward drive pedal. The further
forward the pedal is moved, the faster the rider will
travel. The pedal will return to its original position
when released.
Reverse Pedal
The reverse drive pedal is located on the front, right
side of the running board. Ground speed is also
controlled with the reverse drive pedal. The further
downward the pedal is moved, the faster the rider
will travel. The pedal will return to its original position
when released.
Brake Pedal
The brake pedal is located on the left
front side of the running board. The
brake pedal can be used for sudden
stops or setting the parking brake.
NOTE: The brake pedal must be fully depressed to activate the
safety interlock switch when starting the rider.
Transmission Bypass Rods
The transmission bypass rods (one for each transmission) are
located under the rider on the back of each transmission inside
the rear wheels.
When engaged, the two rods allow the rider to be pushed a short
distance by hand. Refer to the Assembly & Set-Up section for
instructions on using the bypass feature.
Cup Holder
The cup holder is located on the RH console to the right of the
key switch.
Storage Tray
The storage tray is located at the rear of the RH console next to
the cup holder.
Seat Adjustment Lever
The seat adjustment lever is located below the left side of the
seat. Refer to the Assembly & Set-Up section for instructions on
adjusting the seat position.
Charging Port
The charging port is located on the LH console. To access the
charging port, lift up on the charging port cover.
12 S 4— c
ection ontrolS
& F
eatureS
Key Switch (Batteries)
The key switch is located on the RH console and sends power
to the ignition control module when the switch is in the ON
position. The rider cannot be started unless the key switch is in
the ON position. Turning the switch to the OFF position turns
the rider off and stops the flow of power to the vehicle control
module.
Blade Start/Stop Knob
The blade start/stop knob is located on the RH
console next to the key switch.
The blade start/stop knob operates the electric
motors on the deck. Pull the knob upward to
engage the blades, or push the knob downward
to disengage the blades.
NOTE: The blade start/stop knob must
be in the OFF position when starting the
rider.
Cruise Control On/Off Button
CRUISE CONTROL ON / OFF
Pressing the cruise control on/off button while the rider is in
motion allows the rider to remain at a constant ground speed
without applying pressure to the forward drive pedal. The cruise
control can be disengaged by pressing either the cruise control
button, the brake pedal, the forward drive pedal or the reverse
drive pedal. Refer to the Operation section of this manual for
detailed instructions regarding the cruise control feature.
NOTE: Cruise control will not engage at the rider's fastest ground
speed. If the operator should attempt to do so, the rider will
automatically decelerate to the fastest optimal mowing ground
speed.
NOTE: Cruise control will not engage in reverse.