MICRO-MARK 60514 Operating Instructions

OPERATING INSTRUCTIONS FOR
#60514 MICROLUX MULTI-SAW

FOREWORD

Dear Customer:
The MicroLux Multi-Saw is a high performance tool for every
model maker, and is ideal for the sawing of curves in wood,
plastic and non-ferrous metals.
State-of-the-Art production and testing procedures ensure
the maximum reliability from your power tool.
This manual comprises:

• Safety instructions

• Installation and operating instructions
• Spare parts list
• Warranty information
Reading this manual will:
• Help you understand the machine's operation.
• Avoid malfunctions due to improper operation.
• Increase the life of the machine.
Always keep this manual close at hand.
Do not operate the machine unless you are fully familiar
with it. Please observe the safety instructions.
Use only original MicroLux spare parts.

PARTS BAG

Your parts bag contains the following parts:
• 1 Rip fence
• 1 Miter gauge
• 1 Pack of saw blades
• 1 Machine screw and washer
• 3 Wood screws
• 1 Long Allen wrench
• 1 Short Allen wrench (not needed)
SAFETY INSTRUCTIONS
Please read the following safety instructions thoroughly
and follow them before starting to work with the machine:
• Keep the work area clean and tidy.
• Do not use electric tools in rain, under wet conditions,
near flammable liquids or gasses.
• Avoid contact with grounded parts, such as pipes,
radiators, cookers or refrigerators.
• Store tools out of the reach of children.
• Do not overload the machine.
• Do not wear loose clothes or jewelry.
• Do not carry the machine by the electric cable or bow.
• Keep the electrical cable away from heat, oil and sharp
edges. If necessary have it replaced by a specialist.
• Fasten the machine securely to a work table.
• Replace dull saw blades.
• Clean the machine thoroughly after completing your work.
• Pull out the electric plug before maintaining the machine,
before changing the saw blade or the toothed belt, or
when not using the machine.
• Make sure that the machine is switched off before
connecting it to the wall outlet.
• Check the machine for obvious damage before use.
Replace defective parts.
• Repairs in the electrical system should be carried out by
a specialist.
• Use only accessories and spare parts which are
recommended in these instructions.
• Use a push stick when working near the saw blade.
Fig. 1