Diagrams - Sony D-NE1 Service Manual

D-NE1/NE9
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side B) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side A) the parts face are indicated.
• MAIN board is multi-layer printed board. However, the pat-
terns of intermediate-layer have not been included in the dia-
gram.
• WAVEFORMS
1
IC601 if RFAC
100mV/DIV, 400ns/DIV
590 mVp-p
5
IC701 e; XTAL
1V/DIV, 20ns/DIV
3.1 Vp-p
44ns
12
SECTION 5

DIAGRAMS

2
IC601 rk XTAO
1V/DIV, 20ns/DIV
2.1 Vp-p
59ns
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or
less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and
1
• % : indicates tolerance.
• C : panel designation.
Note:
The components identified by
mark 0 or dotted line with mark
0 are critical for safety.
Replace only with part number
specified.
• A : B+ Line.
• Total current is measured with CD installed.
• Power voltage is dc 4.5 V and fed with regulated dc power supply
from DC IN jack (J401).
• Voltages and waveforms are dc with respect to ground in playback
mode.
no mark : CD PLAY
* : Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production toler-
ances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production toler-
ances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY (ANALOG OUT)
c : CD PLAY (OPTICAL OUT)
When IC803 is damaged, replace the MAIN board.
3
IC801 wk XIN
1V/DIV, 40ns/DIV
3.1 Vp-p
118ns
/ W or less unless otherwise specified.
4
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce portant le numéro spécifié.
4
IC403 ef SYNC
1V/DIV, 2us/DIV
2.4 Vp-p
5.7us