Lights; Replacement Of Bulbs; Headlight Beam Adjustment; Changing The Wiring Diagram For Vehicles With Compulsory Lighting On - MOTO GUZZI 850 T3 Workshop Manual

LIGHTS (U.S.A. model)
HEADLIGHT
- Sealed beam insert type: 45/ 40 W - 12 V.
TAil LIGHT
- Number plate lighting parking light and stop
light: bulb 5/ 21 W - 12 V.
Turn signals: 21 W - 12 V.
Indicators, instrument panel: bulb 1,2W - 12V.
Ind icators, mile and rev. counters: bulb 3 W -
12 V.
REPLACEMENT OF BULBS (fig. 212/ 1)
TAIL LIGHT
Undo screws « C » securing reflector to tait
light ; push bulb inwards and turn it to the
left at the same time, then slip it off.
TURN SIGNALS
- Undo sc rews
«
0 .. securing reflectors to si-
gnal lights; push bulbs and tu rn them to the
left al the same lime, then slip them off.
By re-titllng of reflectors screw in uniformly, do
not lock screws too much to prevent braking
of same.
100
INSTRUMENTS PANEL, MILE AND
REV. COUNTERS
- Slip off bulb sockets and replace bulbs.
HEADLIGHT BEAM ADJUSTING (1;9. 212/ 1)
For a safe riding and not to trouble crossing ri-
ders, the headlight beam has always to be set
at a corrent height.
For horinzontal setting act on screw .. A ".
For vertical setting undo connections .. E " and
shift the headlight by hand up or down in order
to get the correct height.
The centre of the high beam must not be higher
than 0,86 m measured at 3 m distance with
motorcycle not on stand and rider on saddle.
CHANGING THE WIRING DIAGRAM FOR
VEHICLES WITH COMPULSORY LIGHTING ON,
WHEN STARTING THE ENGINE
To achieve this change it is necessary to take
off the wire group wh ich connects connector
.. 35 " to fuse n. 4 (red cable) and to connection
.. 40" (yellow cable) . This wire group is con-
nected to connector .. 35 .. throug h connector
« 39 ".
After disconnecting the yellow cable (rear par-
king light) from con nector « 40 .. , con nect it to
fuse n. 4 as Indi cated in t he wiring diagram .
Connector «35» will be re-fitled, into the insu-
lated housi ng which supports the flasher unit
for turn sig nals.
This c hange accomplished, notice that instru-
ment lights and indicator light " I .. (Low beam)
are not protected by fuse n. 4 but by fuse n. 3.