Page 2
MOTOR SCRUBBER IS POWERED BY DC CURRENT ONLY. DO NOT ATTEMPT TO OPERATE MOTORSCRUBBER WITH AC CURRENT. • Never pull the MotorScrubber by its cord or yank it to disconnect it from the battery. • Keep the cord away from heat, oil and sharp edges.
Page 3
(See Fig. 4). To operate the MotorScrubber using the 25’ cord (MS-1025), connect the electrical plug from the MS-1025 to the electrical plug attached to the handle, then connect the other end of the MS-1025 to either the MS-1020 12VDC vehicle battery post adapter, the MS-1022 cigarette lighter adapter, or the battery pack.
Page 4
CHANGING A MOTORSCRUBBER BRUSH • Line-up the tabs on the disc with the hub on the MotorScrubber. • Hold the hub to prevent rotation. Press down while turning the disc clockwise until it locks in place.
Page 5
You may also mix soap concentrate in a bucket and dip the scrub head into the bucket. • Scrub with straight, light strokes. You do not have to exert pressure. MotorScrubber will do the work. • DO NOT USE MOTORSCRUBBER WITH FLAMMABLE CLEANING FLUIDS.
Page 6
• Non-spillable The battery pack contains a fuse for protection against a short circuit. If your MotorScrubber will not run, open the fuse holder in the battery pack and check the fuse. Replace if necessary with: 30 AMP-32 VOLT, ABC GLASS FUSE (MSS038).
Do not allow the cord to hang over the edge of a table or counter, or touch hot surfaces. • Do not use charger for any other uses other than MotorScrubber batteries; other batteries may explode. • Do not operate charger with damaged cord or plug, have them replaced immediately.
Page 8
The warranty certificate is not completed and returned to MotorScrubber. In no event shall MotorScrubber be liable for any damages beyond repair or replacement as described above, including without limitation, warranties of merchantability and fitness for a specific purpose. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Need help?
Do you have a question about the MS2000S and is the answer not in the manual?
Questions and answers