Summary of Contents for HeliArtist HA600MD500
-
Page 2: Important Notes
Thank you for buying YB Products.600 scale fuselage is designed as an easy to use. Please read the manual. carefully before assembling the model,and follow all precautions and recommendations located within the manual.Be sure to retain the manual for future reference,routine maintenance,and tuning.The scale fuselage is designed for T-REX 600Nitro Helicopter series use.you can easily put it on your T-REX 600Nitro for new clothing. -
Page 3: Before Assembling
homes or crowds of people.R/C aircraft are prone to accidents,failures,and crashes due to a variet of reasone including,lack of maintenance,pilot error,and radio interference.pilots are responsible for their actions and damage or injury occurring during the operation or as of a result of R/C aircraft models. - Page 4 Insert the skid pipes into the front Glue the Landing Gear in the body and rear landing skids as illustration. like the picture. Stick the landing gear with the Insert the set screw to lock the skid body like the picture. pipes and landing gear like the picture.
- Page 5 Stick the Wood pieces under the Body. Glue the wood pieces together to form (Hex Put the frame into the Case. two wood blocks.(Remarks: the hight of Cap Screw2x20mm x4;washer ￠3.2x the wood block is depend on what heli ￠8x0.5mm x4) you use.) Put the Sponge inside the tail.
- Page 6 Glue the Taillight cover on the Glue the Headlight cover on the head tail. like the picture. Glue the Doll on the seat. Glue the seat in the head. Glue the Landing Gear in the body Stick and make sure the Vertical Glue the Horizontal Stabilizer Stabilizer alignment the tail.( Hex with the Vertical Stabilizer.
- Page 7 Glue the Horizontal Stabilizer on the Stick the Antenna under the tail. Vertical Stabilizer like the picture. (Make sure it is balance.) like the picture.