Replacing The Front Audio And Usb Assembly - Lenovo ThinkCentre M79 Hardware Maintenance Manual

1. After you have removed the microprocessor from the failing system board, close the microprocessor
retainer and then put the lever to the locked position to secure the retainer in place.
2. Note the orientation of the socket cover, and install one side of the socket cover onto the microprocessor
socket. Carefully press the other side of the socket cover downward until the socket cover snaps
into position.
Note: Your microprocessor socket and cover might look slightly different from the illustration.
Figure 53. Installing the socket cover onto the microprocessor socket
3. Carefully check the four corners of the socket cover to ensure that the cover is seated securely.
4. Follow any additional instructions included with the replacement part you received.

Replacing the front audio and USB assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the front audio and USB assembly, do the following:
1. Remove any media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 101.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 102.
4. Pivot the drive bay assembly upward and disconnect the front audio and USB assembly cables from the
system board and note the cables routing. See "Locating parts on the system board" on page 34.
5. Lower the drive bay assembly. See "Accessing the system board components and drives" on page 104.
.
Chapter 11 Installing or replacing hardware
133