Configure Screen - Unitron Element Programming Manual

Configure Screen

In the Configure screen, you can review the
settings for all adaptive parameters and
input. These settings will automatically
default to suggested values based on the
selected autoPro2 destination or manual
program environment.
For Element 16:
Choose the program you wish to adjust by
selecting one of autoPro2's destinations or
one of the manual programs. The active
program will be highlighted in orange. If one
of autoPro2's destinations is linked to a
manual program, both environments will be
highlighted in orange. Changes made to one
program will also be applied to the linked
program.
For Element 8 and 4
Choose the program you wish to adjust by selecting one of the manual programs. The
active program will be highlighted in orange.
Select a Processing Strategy for each of the enabled programs from the drop-down list.
The processing strategy can be individually selected for each environment or program.
• Select the desired Phase Canceller setting.
Note: You must run the Feedback Optimization test first or the phase canceller option
will not be active.
• Select the desired Noise Reduction setting.
• Select the desired Wind Noise Manager setting.
• Select the desired antiShock
For Element 16:
• Select the desired Speech Enhancement LD setting.
For Element 8:
• Select the desired Speech Enhancement setting.
• Select an option from the Input drop-down list.
Note: Exact choices will depend on the chosen destination or listening environment.
• For the environments that offer the Mic+Telecoil or Mic+DAI options, the balance
between the microphone and the Telecoil or DAI can be adjusted. Options are:
-12 dB, -9 dB, -6 dB, -3 dB or 0 dB.
The Configure screen also lets you manage the manual programs as well as change
environments in any of the manual programs.
To change the environment, click the drop-down list beside any of the manual programs
and select the appropriate environment.
To deactivate a manual program, select the option None from the drop-down list, starting
with the last program. P2 or P3 cannot be disabled if P4 is enabled.
™
setting.
Element Programming Guide