Dust Extraction - Makita 4351T Instruction Manual

CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the position
shown in the figure. Pull the saw blade out toward the
base.
1
008009
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
008033
When not in use, the hex wrench can be conveniently
stored.
Anti-splintering device
2
008028
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
1. Jig saw blade
1. Base
2. Hex wrench
1
2
1. Base
2. Anti-splintering
device
1
Cover plate
008027
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.

Dust extraction

The dust nozzle (optional accessory) is recommended to
perform clean cutting operations.
001921
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
The dust nozzle can be installed on either left or right
side of the base.
001922
Then connect a Makita vacuum cleaner to the dust
nozzle.
1
2
008039
6
1. Cover plate
1
2. Base
2
1. Dust nozzle
1
2. Base
2
1. Dust nozzle
2. Hose for vacuum
cleaner