Connecting To A Vcr Or Other Similar Device - Philips DVDR3440H User Manual

Connecting to a VCR or
other similar device
This connection enables you to record
from a video tape to the HDD or a
recordable DVD and allows the VCR to
be used for playback if the recorder is
turned off.
IMPORTANT!
Your new recorder can replace the
VCR for all your recording needs.
Just unplug all the connections to
your VCR.
A
Connect the existing Aerial/Satellite/
Cable TV signal (or from the Cable Box/
Satellite Receiver, labelled as RF OUT or
TO TV) to the ANTENNA
the recorder.
TIPS: Refer to the respective connected device's user manual for other possible connections.
dvdr3440h_05_eng_24282.indd 19 dvdr3440h_05_eng_24282.indd 19
Downloaded From Disc-Player.com Philips Manuals
Step 2: Optional Connections
ANTENNA SATELLITE CABLE
~
MAINS
TV
VHF/UHF OUT
RF IN
TV OUT
VIDEO
OUT
AUDIO
L
VHF/UHF
AUDIO
RF OUT
R
A
AN-
TENNA
S-VIDEO
EXT 2 AUX - I/O
(Y/C)
TV
EXT 1 TO TV - I/O AUDIO / VIDEO OUT
B
B
Use another RF coaxial cable to connect
the TV
aerial input socket on the TV.
C
Use the SCART cable to connect the
EXT1 TO TV-I/O scart socket on the
recorder to the corresponding SCART
input socket on the TV.
D
Use another SCART cable to connect the
EXT2 AUX-I/O scart socket on the
recorder to the SCART output socket
(or labelled as TV OUT or TO TV) on
the VCR.
Helpful Hints:
– Most commercial video cassettes and
DVDs are copy-protected and therefore
cannot be recorded.
– Connect the recorder directly to the
socket on
TV. If there is a VCR or an additional device
in between, the picture quality may be poor
because of the copy protection system built
into the recorder.
(continued)
Back of a VCR
IN
TV IN
VIDEO
IN (Example only)
AUDIO
L
AUDIO
R
D
VIDEO
(CVBS)
L
AUDIO
R
COAXIAL
DIGITAL AUDIO OUT
C
socket on the recorder to the
2007-05-28 5:19:55 PM 2007-05-28 5:19:55 PM
19