LG PF1000U Owner's Manual page 5

• Do not install the product in a
place with no ventilation (e.g.,
on a bookshelf or in a closet) or
on a carpet or cushion.
– This may result in fire due
to the increase in internal
temperature.
• Do not place the product close
to sources of steam, oil or oil
mist, such as humidifiers and
kitchen counters.
– Failure to do so may result
in fire, electric shock, or
corrosion.
•
Do not install the product onto
a wall or ceiling that is close to
sources of oil or oil mist.
– The product may be
damaged and fall, resulting in
serious injury.
• Do not place the projector where
it might be exposed to dust.
– This may result in fire.
• Do not use the projector in a
damp place such as a bathroom
where it is likely to get wet.
– This may result in fire or
electric shock.
• Do not allow a tablecloth or
curtain to block the air vent.
– This may result in fire due to
the increase in the internal
temperature.
• Ensure good ventilation around
the projector. The distance
between the projector and the
wall should be at least 30 cm.
– This will prevent fire due to
the increase in the internal
temperature.
SAFETY PRECAUTIONS
CAUTION
• When placing the projector on a
table or shelf, be careful not to
put it near the edge.
– The projector could fall due
to balance problems, which
may cause personal injury or
damage to the product. Make
sure to use the projector
cabinet or stand that fits the
projector.
•
When moving the projector,
make sure to switch it off and
remove the power plug and
cords.
– The power cord may be
damaged, resulting in fire or
electric shock.
• Do not place the projector on
an unstable or vibrating surface
such as a wobbly shelf or a
slope.
– It may fall and cause injury.
• Be careful not to tip the projector
over when connecting external
devices to the projector.
– This may cause personal
injury or damage to the
projector.
Power
WARNING
• The power plug is the
disconnecting device.
– In case of an emergency,
the power plug must remain
readily accessible.
5