Table of Contents
Advertisement
PRINTING THE DATE/TIME
20
First select the date/time mode you want to print.
Press the MODE button. As you
press it, the mode will switch in
the order shown below.
Keep the mode you want to print
displayed.
None
Year-month-day
Month-day-year
Day-month-year
Day-hour-minute
• The date unit uses the same power source as the camera.
• Be sure to correct the date and time after the battery is replaced.
• The date/time is imprinted in the lower right corner of the picture.
• If the date/time is superimposed on a bright color like white,
orange, yellow, etc., it may be difficult to read.
• The date/time may not be imprinted correctly on the frame(s) after
the specified final exposure of the film.
• When black-and-white film is used, the date/time may not be
printed.
2754 Q20N_EN
20-21
CARE AND STORAGE
Do not leave the camera in any place exposed to excessive heat,
humidity or direct sunlight — for example, in a car or on the
beach.
Do not expose the camera to formalin or naphthalene.
If the camera gets wet, wipe it with a dry towel. The salt in
seawater can be especially damaging.
Do not use organic solvents such as alcohol or paint thinner
when cleaning the camera.
Do not leave the camera on or near a television, refrigerator or
other appliance with a magnetic field.
Do not expose the camera to dust or sand as this could cause
serious damage.
Do not shake the camera.
Do not apply excessive force to the zoom lens.
Do not expose the camera to extreme heat (over 40°C/104°F) or
to extreme cold (below –10°C/14°F). Low temperatures, even
within this range may sometimes cause deterioration in battery
performance, temporarily disabling the camera.
Avoid leaving the camera unused for long periods of time. This
can cause mold to grow on the camera as well as other
problems. Try to press the shutter release button and check the
operation of the camera before use.
Some airport X-ray machines can damage the film in your
camera. Try to avoid passing your camera through these
machines. Give it to the security officer for manual inspection.
Do not touch the front surface of the flash after using it
continuously over a short period as the surface may be hot.
02.11.18, 8:44 PM
21
Hide quick links:
Advertisement
Table of Contents
